Monday, October 3, 2011

carpet cleaning procedures::A great all purpose carpet cleaning solution is our carpet cleaning procedures

carpet cleaning procedures

carpet cleaning procedures

carpet cleaning procedures

carpet cleaning procedures::A great all purpose carpet cleaning solution is our.
Fill the solution tank of your extractor with the proper amount of chemical and water.
If it is nonheated unit, it is a good idea to fill your solution tank with hot tap water.
Attach all hoses and the necessary tools.
Place a few ounces of a defoamer into a container and suck it up through the drag wand.
This will coat all surfaces through the wand, hoses, and recovery tank, eliminating foam as the shampoo is recovered.
Remove all furniture and other obstructions from the carpeted area that you will be cleaning.
Vacuum the area with a powerful vacuum, like our , to remove as much dirt as possible before the extraction takes place.
If there are any stains, those will need to be treated with the proper stain remover and portable spotter.
Follow the for each possible type of stain.
Place the extractor in a remote position, often in a corner towards the entrance to the room.
Plug extractor into a 3pronged outlet.
Often times a circuit locator is built into the machine or comes an accessory that can tell you if 2 outlets are, or are not on separate circuits.
This can be accomplished with a.
If the area is not completely and totally filled with dirt, you can move right into the first steps of extraction.
Start at a point that is furthest away from the entrance to the room.
Make a forward pass, laying down a stream of solution, then come back with the vacuum head on the drag wand and extract the solution you just put down.
Move over and repeat the same steps.
Overlapping by a few inches will guarantee a thorough cleaning.
Flip on the switches for the pump, vacuum and brush.
As the switch is depressed solution will be sprayed onto the carpeted surface and the brush will spin.
The brush will come over that area and scrub the carpet, and then the vacuum shoe will come over that area and remove the solution.
Go over that area with the vacuum shoe to ensure all solution is recovered.
Lean the machine back and walk forward to start your next pass.
Overlap a few inches to ensure proper coverage.
Use a hand tool with your extractor, or a small portable spotter to clean up any areas that are unreachable by your larger extractor.
Use the exact same procedures with just a clean tank of water to rinse out the carpet and remove as much of the shampoo as possible.
Think of this last step as a rinse, similar to what happens when doing a load of laundry in your washing machine.
This will help to move as much air as possible across the damp carpet to dry it as quickly as possible.
A dump valve can be backed up to a toilet, bucket, floor drain, or slop sink and dumped.
If there is any clean solution left in the solution tank, simply take the vacuum hose and suck up the rest of the clean solution.
Then again dump out the recovery tank.
Flush out and clean both tanks as thoroughly as possible.
Leave the tank covers off to allow the tanks to air out and deodorize.
Your carpet extractor should be winterized between uses if it is to be exposed to freezing temperatures.
Run the pump until fluid flows through the tank, and all attachments.
Then run 1 gallon of water through the extractor before the next use.
carpet cleaning procedures::Every great carpet cleaning and restoration
company starts with a proper, precise carpet, tile or upholstery
preinspection carpet cleaning procedures

No comments:

Post a Comment